Hey guys, I need a little help. I loaded up Release 65 onto my Taz 6 and it worked great. Then one morning I went to home Z and it started homing the original way. I thought ok I’ll just reload release 65 again now all it get, is “firmware failed to load”. I read somewhere to try to load release 39 which I did. It loaded great. But it still homes to the back left corner. WTH!!
Can anyone help with this? Greatly appreciated🤞
Well, it seems like the end stop on the right side of the X-axis is normally closed…ok, all the end stops I’ve dealt with so far are normally open. My bad
1 Like