Unable to use OctoPrint

1

Hi,

Just managed to get my Taz6 & Archim2 running with DO, my word is it quiet! However when I try to connect to the printer using OctoPrint v1.6.1, it connects but a couple of seconds later it disconnects and the printer reboots. The terminal in OctoPrint shows:

Send: M876 P1
Recv: ok P15 B4
Send: M20
Recv: Begin file list
Recv: /DOCUME~1/MANUAL/SOURCE/MANUAL.GST 363
Unexpected error while reading serial port, please consult octoprint.log for details: SerialException: 'device reports readiness to read but returned no data (device disconnected or multiple access on port?)' @ comm.py:_readline:3860
Please see https://faq.octoprint.org/serialerror for possible reasons of this.
Changing monitoring state from "Operational" to "Offline after error"
Connection closed, closing down monitor

Any idea of what is up?

Thanks

2

Looks like this was caused by something on the SD card, everything works fine when I remove the SD card. Will have a look what’s on the SD card, but I think it has the standard files from Lulzbot and a handful of my gcode files on it.