I just got a brand new Titan Aero toolhead for my Taz 6 and flashed My machine with
Marlin_Oliveoil_TAZ6Archim_Angelfish_Aerostruder_2.0.0.1_0a41173f8 but its not working like it should.
It will not home and presses down real hard on the left rear touch washer and I have to turn the machine off to get it to stop. Is there another version of software to use with the Aerostruder/Archim 2 board for the Taz 6?
Does it press really hard on the z min switch, or the left leveling washer?
its pressing on the leveling washer
there is a z max switch and an x min switch but I can’t find a z min switch.
For now I’m going to put my standard single extruder back on the printer and see if it functions normally again.
Its not making contact with the leveling washer.
for now I’m going back to the regular single extruder and now the problem axis is the Y axis. Z and X are working fine.
just found out the wire for the Y axis was loose. I plugged it back in and now the heat bed is traveling back and forth. I’ll add that to my list of things to check in the future.
I believe the z min is the button that the nozzle presses before it goes to the wiper.
I’ve got my old single extruder working again. Not sure when I’m going to feel up to trying out the Titan Aero again, but I think it was a loose wire that caused the problem I was having.
@JMal3: Cecropiasilk_AeroStruder firmware?
Marlin_Oliveoil_TAZ6Archim_Angelfish_Aerostruder_2.0.0.1_0a41173f8
This is what I am using but it doesn’t seem to be doing what its supposed to do. Is there another version that works better? This is with the Archim 2 board and Drunken Octopus.
I was using the wrong flash .bin file. I found the correct one.