I have been searching Google for a few days and struggling to get good info. My Rambo bit the dust, and I want to swap with a SKR 3 EZ board. I’m struggling to figure out how the firmware works. I want to use BL Touch, but am a noob. I’m not sure how to configure this board or firmware. I’m just looking for a point in the right direction, thank you 
Hi FunkyNuggets. Drunken Octopus is meant only for Ultimachine boards such as the Rambo and Archim boards. Although Marlin supports other boards, you would need to edit the appropriate board configuration in Configuration.h and recompile the firmware yourself. To save a bit of time, you could use the Drunken Octopus configurations as a starting point – these are available in the archives in the GitHub repo inside the config/examples folder.
1 Like