Running into a bit of an issue where my carriage is ramming the idler when probing. Any idea on either a version of firmware with x_max endstop enabled or a version with the bed defined slightly smaller?
Taz6
Archim2
X&Y Openbuild Conversion
BLTouch
Titan Aero
Figured it out. Was running the wrong firmware. Looks like I selected aero v2 rather than v1 which has x_max endstop enabled.
@marciot - Is there a cheat sheet for extruder codename to actual extruder specs?
There isn’t a cheat sheet per se. The codenames are a carry over from AlephObjects and it looks like Fargo Additive Manufacturing isn’t continuing with that tradition.