Checked the config files for my setup: Taz 5 with Archim 2.0 and BLTouch, to match up with previous release config files. After compiling the DO R71 firmware and updating the board, the printer does fine for about 10 layers then something causes the filament to stop feeding out of the extruder (original Hexagon with 0.5 nozzle). When filament is pulled from the extruder, it appears to have lost temperature causing a blockage and stops the filament flow. Carriage continues to follow the gcode instructions.
Finally went back to the DO Release 62 firmware build and the printer functions properly. What might be cause for Release 71 causing this issue?
thank you for the input.